» Support » Downloads » Drivers
Drivers for OEMPA digitizers
Drivers for OEMPA digitizers for InspectionWare 10 and later
Note:

The drivers provided on this page are only for the versions of InspectionWare 10.0.0.8 and later.

InspectionWare 10 and 10.5 require driver version 1.1.5.3.

InspectionWare 11 and later require driver version 1.1.5.4.

OEMPA 128/128 and 256/256 with the USB3 connector require the OEMPA128128USB-Driver.

The following drivers are provided as a courtesy to UTEX Scientific Instruments customers, and are therefore offered on an "as is" basis. UTEX does not maintain or support these drivers. If you are unsure of what driver to use, please consult the hardware manufacturer directly, or contact UTEX for further guidance.


Supported A.O.S. Instruments:

    OEMMC and OEMPA instruments, up to 256 channels

Prerequisites:
    None.

Installation Instructions:
    1. Please see the "Driver Files" section below
    2. Ensure you download the correct version of drivers (32 or 64 bit ) for the version of InspectionWare that you are using. You can run 32 bit InspectionWare on a 64 bit PC, but you must then also run the 32 bit version of the drivers for this instrument.
    3. If you have another 32 or 64 bit version of the drivers already installed with the same version number, you must uninstall the existing drivers before installing the new version. The 32 and 64 bit drivers will install alongside each other, but the application software cannot necessarily determine which version you want to use.
    4. Right-click on the file name and choose "save target as" or "save..." to download the file to your computer.
    5. Double-click on the downloaded EXE file to start the installation.

You should now be able to access the cards via the acquisition software.


Related Files
Document Reference
Categories
NDE Software
InspectionWare 
Product Version/Model
10.0.0.8 
Document Number
DSEO-9HJLHC4606
Published
03/25/2014 Rev: 1.0
  Print Email page Share