» Support » Downloads » Drivers
Installer for Olympus OpenView SDK (1.0R27 and Later)
Installer InstallOpenView

    The following drivers are provided as a courtesy to UTEX Scientific Instruments customers, and are therefore offered on an "as is" basis. UTEX does not maintain or support these drivers. If you are unsure of what driver to use, please consult the hardware manufacturer directly, or contact UTEX for further guidance.

    Only 64bit drivers are available for versions 1.0R13 and later.

    Manual un-install is required when moving between versions before and after R20.

Supported Instruments:

    Olympus Focus PX

System Requirements:
    • InspectionWare 11.0.028 and later.
    • Not compatible with Olympus Focus PC, Olympus TomoView, or Olympus NDT Bootp Server.
    • Installer must be run as an Administrator.
    • Network card settings should be set according to Olympus specification as follows:
Download Instructions:
    1. Please see the "Related Files" section below
    2. Ensure you download the correct version of SDK for the version of InspectionWare that you are using.
    3. Right-click on the file name and choose "Save Target as" or "Save..." to download the file to your computer.
    4. Right-click on the downloaded *.exe file, and select Run As Administrator to start the installation.


    Firewall must be correctly configured to allow traffic for the dedicated network connection . You may need to disable firewall in order for Focus PX communications to work correctly

Access to downloads on this page is restricted.
Please provide the following:
( Required field)
Download Password:
The following file links will become active once the required information is submitted:
Related Files
InstallOpenView64-1.0R27.exe (63.9 MB)
InstallOpenView64-1.0R36.exe (63.6 MB)
InstallOpenView64-1.0R37.exe (60.9 MB)
Document Reference
NDE Software
Product Version/Model
IW 11.0 
Document Number
10/24/2019 Rev: 2.0
  Print Email page Share