|
| Welcome to UTEX Scientific support, your technical resource gateway. You can search all support resources or concentrate on a particular product or area.
Show resources for a specific product:
|
Show only specific category:
|
|
|
| Windows Upgrade Assessment Windows Upgrade Assessment to help you assess the future of your Windows XP-based UTEX inspection system. » Support » Knowledge Base » Hardware Support | 2014/10/23
10:47:59 AM | | Utex Windows XP Support Notice Your UTEX system PC is an industrial controller that hosts specialized components for motion control and high speed data acquisition. It should not be upgraded before contacting UTEX technical support for advice. » Support » Knowledge Base » Hardware Support | 2014/10/23
10:43:56 AM | | Resolving Winspect time-out error for Galil DMC 18xx motion controllers Winspect 5.5 and 6.x scanning systems using Galil DMC 18xx controllers may report a time-out error from the Galil motion controller during scanning. This note describes how to configure the Galil DMC drivers to eliminate the problem. » Support » Knowledge Base » Hardware Support | 2012/08/13
12:35:46 PM | | Hardware Drivers for Winspect 6.x versions This article lists the appropriate drivers for popular motion control and instruments hardware running under Winspect 6.x and Windows XP operating systems. » Support » Knowledge Base » Hardware Support | 2010/12/23
05:04:27 PM | | How to run Winspect and InspectionWare on the same computer This document describes how to setup your workstation to run Winspect and InspectionWare on the same computer. » Support » Knowledge Base » Application Notes | 2009/10/14
02:10:10 PM | | Assembly Diagram for NI 6601 Cable Assembly (UTEX Part # AY13-072-001) » Support » Knowledge Base » Application Notes | 2008/01/23
03:18:40 PM | | Backing Up the Winspect System It is a good practice to back up your Winspect system on a regular basis. This protects you against accidental file deletions, and against computer-related disaster, such as hard-drive failures, water or fire damage, and so on... » Support » Knowledge Base » Application Notes | 2008/01/23
01:29:02 PM | | Using Phoenix Contact Optima MD/100 Interconnect Modules The Phoenix Contact Optima MD/100 module provides a convenient field termination for motion control signals that are interfaced to a Galil motion control card, such as the DMC 1700 and DMC 1800 series... » Support » Knowledge Base » Application Notes | 2008/01/23
01:10:46 PM | | Ways to to use motor controllers and encoder interface cards for scanning Winspect and InspectionWare can be configured in many different ways to collect NDT data. » Support » Knowledge Base » Application Notes | 2008/01/23
01:03:25 PM | | Adding a pre-trigger enable output to the Sonix STR81G digitizer Instruments with uncertain trigger timing -- Some ultrasonic systems when externally triggered are not immediately able to generate their main output pulse. These systems include flaw detectors with trigger jitter, multiplexers that need to first switch to the next channel and EMAT systems that first need to build up energy.... » Support » Knowledge Base » Application Notes | 2008/01/23
11:21:07 AM | | Adding a pre-trigger enable output to the Sonix STR8100 digitizer Instruments with uncertain trigger timing -- Some ultrasonic systems when externally triggered are not immediately able to generate their main output pulse... » Support » Knowledge Base » Application Notes | 2008/01/23
11:12:31 AM | | Manual Scanning Modes An illustrated guide to manual scanning modes supported by Winspect and InspectionWare » Support » Knowledge Base » Application Notes | 2007/12/07
02:54:17 PM |
| |